Other products by Summit Source
Item #: MW5048
Part #: MW5048
Reg. Price: $44.95
Our Price: $39.95


Eagle Non-Penetrating Roof Mount and Universal J-Pipe DBS Satellite Mounting Kit Dish Roof Mount Non-Penetrating Ideal for Dish Antennas up to 24" Inch, Satellite Dish Antenna Mount

 Non-Penetrating Roof Mounts solve the problems associated with flat-roof installations. They are also an alternative when a non-permanent installation is required, or one that may be moved to other sites. Base frames and post kits can be combined in various ways to support antennas up to one meter. 

 This bases frame is manufactured from 1.25" x 1.25" x 0.188" angle iron. Base frame has a seven step thermoset powder coat finish. This base is PRE-DRILLED to fit most antenna bases. The roof mount is for 46 and 60 cm antennas with mounting feet. Single base frame covers approximately six square feet. 25.5" x 37.5" square.

 The J-Pipe mount is designed for outdoor antennas. It can be used on the side of a house or roof; mounting foot can be used on either end of pipe for best mounting. Pipe galvanized steel, 39 inches long, with a wall thickness of .060 inches, 1.66" OD, E-Coated for maximum protection. Please Note: Mount is not designed for large directional antennas.

Hardware Kit Includes:

  • 4 - 1/4" Screws 3" long
  • 2 - 1/4" Lag Bolts 7/16" Hex Head 3" Long
  • 4 - 5/16" Lag Bolts 1/2" Hex Head 2" Long
  • 4 - 1/4" Flat Washers
  • 4 - Concrete Anchors (1/4" Bolt, 1/2" Drill)


Please Note:  Rubber Mat not included. This listing is for the purchase of the J-Pipe pole and Non-Penetrating base only.


Be the first to submit a review on this product!
Review and Rate this Item

Subscribe To Email List

Enter your email address below to subscribe to Sales & Promotions.


Pin It

Email A Friend

Send your friend a link to this product.